SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010AVEO LT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)REPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT (NOTCHBACK)INSTALLATION PROCEDURE
2010 Chevrolet Aveo LT, 4D Hatchback, Standard

Installation Procedure

2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Remote Control Door Lock Receiver
    GM1859919Courtesy of GENERAL MOTORS CORP.
  1. Install the control module/receiver on its mounting bracket.
  2. Connect the control module/receiver electrical connector.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the knee bolster with bolts and tighten to 10 N m (89 lb in).
  4. Install the instrument panel under cover.
  5. Connect the hood release cable to the hood latch release handle.
  6. Install the screws.
  7. Connect the negative battery cable.
  8. Complete remote keyless transmitter programmming. Refer to Remote Control Door Lock Transmitter Programming 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.