Installation Procedure

2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Onstar Button Cover, Screws & Electrical Connector
    GM2083018Courtesy of GENERAL MOTORS CORP.
  1. Install the OnStar cellular microphone on the interior courtesy lamp.
  2. CAUTION: Refer to Fastener Caution .
  3. Install the OnStar button cover (3) and the screws (1) to the interior courtesy lamp and tighten to 2.5 N.m (22 lb in).
  4. Connect the electrical connector (2).
  5. Fig 2: Interior Courtesy Lamp Retaining Tabs
    GM2083023Courtesy of GENERAL MOTORS CORP.
  6. Install the interior courtesy lamp (1). Refer to Interior Courtesy Lamp Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.