Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010AVEO LT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 54 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSCOMMUNICATION INTERFACE MODULE BATTERY REPLACEMENTREMOVAL PROCEDURE
2010 Chevrolet Aveo LT, 4D Hatchback, Standard
Removal Procedure
2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable.
- Slide the passenger seat forward.
- Disconnect the electrical connector from the Onstar module which is located on the bottom of the passenger seat.
- Remove the bolts (1) and the Onstar battery (2).
WARNING:
Refer to Battery Disconnect Warning
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.