Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2010AVEO LT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 25 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER AND WASHER SWITCH REPLACEMENTINSTALLATION PROCEDURE

2010 Chevrolet Aveo LT, 4D Hatchback, Standard

Installation Procedure

2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wiper Switch

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (2) to the wiper switch.
Install the wiper switch into the switch housing with the tabs (1, 3) on either side of the switch housing.

Fig 2: Steering Column Panels

Courtesy of GENERAL MOTORS CORP.

Install the upper steering column cover panel (1) and the lower steering column cover panel (5).

CAUTION: Refer to Fastener Caution .

Install the lower steering column cover panel screws (6, 7, 8).
Tighten: Tighten the lower steering column cover panel screws to 3 N.m (27 lb in).
Turn the steering wheel in order to access the upper steering column cover panel screw holes. Install the upper steering column cover panel screws (3, 4).
Tighten: Tighten the upper steering column cover panel screws to 3 N.m (27 lb in).
Connect the negative battery cable.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.