SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010AVEO LT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSSTOP LAMP SWITCH ADJUSTMENT
2010 Chevrolet Aveo LT, 4D Hatchback, Standard

Stop Lamp Switch Adjustment

2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Stop Lamp Switch Adjustment
WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to Battery Disconnect Warning .
  1. Disconnect the negative battery cable.
  2. Remove the stop lamp switch. Refer to Stop Lamp Switch Replacement .
    3. Fig 1: View Of Stop Lamp Switch Electrical Connector
    GM1537923Courtesy of GENERAL MOTORS CORP.
  3. Pull out the shaft of the stop lamp switch to its maximum setting point.
  4. Connect the stop lamp switch electrical connector.
  5. Depress the brake pedal to the bottom.
  6. Install the stop lamp switch in the brake pedal bracket hole by twisting.
  7. Release the brake pedal slowly until reaching the end of the stop lamp switch shaft, the stop lamp switch will be adjusted of itself by the reaction force of the brake pedal.
  8. Connect the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.