Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2010AVEO LT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSHEADLAMP REPLACEMENTINSTALLATION PROCEDURE

2010 Chevrolet Aveo LT, 4D Hatchback, Standard

Installation Procedure

2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Headlamp Assembly

Courtesy of GENERAL MOTORS CORP.

Install the headlamp bulb.
Install the retaining wire.
Connect the headlamp bulb electrical connector.
Install the cap concealing the headlamp bulb.

Fig 2: Headlamp Fascia Grille

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors.

CAUTION: Refer to Fastener Caution .

Install the headlamp assembly with the bolts and tighten to 6 N.m (53 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.