Installation Procedure

2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2011 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fog Lamp Assembly
    GM1722994Courtesy of GENERAL MOTORS CORP.
  1. Install the bulb.
  2. Connect the electrical connector.
  3. CAUTION: Refer to Fastener Caution .
  4. Install the fog lamp with the screws and tighten to 5 N.m (44 lb in).
  5. Fig 2: Resonator
    GM1722990Courtesy of GENERAL MOTORS CORP.
  6. Install the resonator with the bolts.
  7. Fig 3: Engine Undercover
    GM1722986Courtesy of GENERAL MOTORS CORP.
  8. Install the engine under cover with the bolts.
  9. Connect the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.