Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Lowering Vehicle
The body is forced upward when an excess load is removed from the rear of the vehicle. This causes the sensor actuating arm to rotate downward. The downward rotation of the actuating arm activates the internal timing circuit. The sensor completes the solenoid valve circuit to ground after an initial delay of 20 seconds. With the solenoid valve energized, the air begins to exhaust out of the shock absorbers back through the air dryer, the solenoid valve, the air compressor filter and into the atmosphere. The sensor actuating arm rotates upward toward its original position as the rear of the vehicle lowers. When the vehicle body reaches its original height +/- 4 mm (+/- 0.16 in), the sensor opens the solenoid circuit, de-energizing the solenoid valve, which prevents any further air from escaping.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.