Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009UPLANDER LT, 3.9 MREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING WHEEL AND COLUMNREPAIR INSTRUCTIONSTILT LEVER REPLACEMENTREMOVAL PROCEDURE
2009 Chevrolet Uplander LT, 3.9 M
Removal Procedure
2009 Chevrolet Uplander LT, 3.9 MSECTION Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling .
- Remove the lower trim cover. Refer to Steering Column Trim Covers Replacement .
- Remove the tilt lever spring (2).
- Remove the retaining bolt (3) from the tilt lever.
- Remove the tilt lever (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.