Powertrain Component Views

2009 Chevrolet Uplander LT, 3.9 MSECTION Powertrain Component Views
Fig 1: View Of Engine Electrical Components
GM1542535Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Fuse Block - Underhood (Battery Stud)
2 G102
3 Battery Current Sensor
4 Generator
5 Automatic Transmission
6 G113
7 G115 (Battery Cable)
8 G115
9 Starter Motor
10 Battery
Fig 2: View Of Engine Components
GM1700522Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Intake Manifold Tuning (IMT) Solenoid Valve
2 Evaporative Emission (EVAP) Canister Purge Solenoid Valve
3 Throttle Body
4 Knock Sensor (KS) 2
5 Starter Solenoid
6 Starter Motor
7 Engine Oil Pressure (EOP) Sensor
8 Camshaft Position (CMP) Actuator Solenoid Valve
9 Camshaft Position (CMP) Sensor
Fig 3: Fuel Rail Components
GM1700526Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Fuel Injector 1
2 Fuel Injector 3
3 Fuel Injector 5
4 Fuel Injector 6
5 Engine Coolant Temperature (ECT) Sensor
6 J142
7 Fuel Injector 4
8 Fuel Injector 2
9 Crankshaft Position (CKP) Sensor
10 X102
Fig 4: Identifying Air Intake System Components
GM1700520Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Mass Air Flow (MAF)/ Intake Air Temperature (IAT) Sensor
2 Engine Control Module (ECM)
Fig 5: Identifying Rear of Engine Components
GM2028651Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Throttle Body
2 Manifold Absolute Pressure (MAP) Sensor
3 Ignition Control Module (ICM)
4 Heated Oxygen Sensor (HO2S) 1
5 Knock Sensor (KS) 1
6 Block Heater
7 Crankshaft Position (CKP) Sensor
8 Engine Coolant Temperature (ECT) Sensor
Fig 6: View Of Heated Oxygen Sensor (HO2S) And Catalytic Converter
GM1700531Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Heated Oxygen Sensor (HO2S) 2
2 Catalytic Converter
Fig 7: Identifying Internal Electronic Component Locations
GM840831Courtesy of GENERAL MOTORS CORP.
Callout Component Name
10 Vehicle Speed Sensor (VSS) Assembly
315a 1-2, 3-4 Shift Solenoid (SS) Valve Assembly
315b 2-3 Shift Solenoid (SS) Valve Assembly
322 Pressure Control (PC) Solenoid Valve Assembly
334 Torque Converter Clutch (TCC) Solenoid Valve Assembly
391 Transmission Fluid Temperature (TFT) Sensor
395 Transmission Fluid Pressure (TFP) Manual Valve Position Switch Assembly
440 Automatic Transmission Input Shaft Speed (ISS) Sensor Assembly
811 Lever Assembly-Manual Shaft Detent with Shift Position Switch - Internal Mode Switch (IMS)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.