Front of Vehicle/Engine Compartment Component Views

2009 Chevrolet Uplander LT, 3.9 MSECTION Front of Vehicle/Engine Compartment Component Views
Fig 1: Front of Engine Compartment Components
GM2028648Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Hood Ajar Switch (AP3/AP8)
2 Inflatable Restraint Front End Sensor - Left
3 Engine Cooling Fan - Left
4 Engine Cooling Fan - Right
5 Ambient Air Temperature Sensor (UH8/UH9)
6 Horn Assembly
7 Inflatable Restraint Front End Sensor - Right
8 Hood Ajar Switch Connector (AP3/AP8)
Fig 2: Identifying Front Fascia Exterior Lighting Components
GM1535953Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Headlamp - Left High Beam
2 Headlamp - Left Low Beam
3 Marker Lamp - Left Front
4 Park/Turn Signal Lamp - Left Front
5 Park/Turn Signal Lamp - Right Front
6 Marker Lamp - Right Front
7 Headlamp - Right Low Beam
8 Headlamp - Right High Beam
Fig 3: Left Front of Engine Compartment Components 1 of 2
GM1861220Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Air Cleaner Assembly
2 Transmission Control Module (TCM)
Fig 4: Left Front of Engine Compartment Components 2 of 2
GM1542536Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Upper Dash Panel
2 Electronic Brake Control Module (EBCM)
Fig 5: Identifying Engine Compartment Components - I/P Harness
GM1536065Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Fuse Block - Underhood
2 Windshield Wiper Motor
3 Brake Fluid Level Switch
4 Windshield Washer Fluid Pump
5 Rear Window Washer Fluid Pump
Fig 6: Right Front of Engine Compartment Components 1 of 2
GM1546083Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Battery
2 X108
3 Rear Window Washer Fluid Pump Relay
4 Instrument Panel Harness
Fig 7: Right Front of Engine Compartment Components 2 of 2
GM1542524Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 A/C CLTCH Relay
2 A/C Compressor Clutch
3 A/C Refrigerant Pressure Sensor
4 A/C Compressor
5 DIODE 3
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.