SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009UPLANDER LT, 3.9 MREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSVEHICLE ACCESSREPAIR INSTRUCTIONSSLIDING DOOR REAR LOCK REPLACEMENTREMOVAL PROCEDURE
2009 Chevrolet Uplander LT, 3.9 M

Removal Procedure

2009 Chevrolet Uplander LT, 3.9 MSECTION Removal Procedure
    NOTE: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.
  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Remove the sliding door inner trim panel. Refer to Rear Side Door Trim Panel Replacement .
  3. Remove the sliding door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  4. Remove the sliding door latch screws.
  5. When the sliding door rear lock is loose, unhook the lock rod from the sliding door rear lock.
  6. Disconnect the detent switch electrical connector.
    7. Fig 1: View Of Sliding Door Latch And Screws
    GM1480602Courtesy of GENERAL MOTORS CORP.
  7. Remove the sliding door rear lock from inside the sliding door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.