Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2009UPLANDER LT, 3.9 MREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSVEHICLE ACCESSREPAIR INSTRUCTIONSLIFTGATE OUTSIDE HANDLE REPLACEMENTREMOVAL PROCEDURE

2009 Chevrolet Uplander LT, 3.9 M

Removal Procedure

2009 Chevrolet Uplander LT, 3.9 MSECTION Removal Procedure

Fig 1: Identifying Liftgate Handle Assembly

GM1479957

Courtesy of GENERAL MOTORS CORP.

Open the liftgate.
Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
Remove the water deflector. Refer to Liftgate Water Deflector Replacement .
Remove the license plate lamp sockets by turning the sockets counterclockwise.
Remove the liftgate handle nuts (1, 2) from the studs inside the liftgate (3).

Fig 2: View Of Liftgate Handle

GM1479958

Courtesy of GENERAL MOTORS CORP.

Remove the bolts (2) from the liftgate handle.
Remove the liftgate latch cable from the handle.
Remove the liftgate handle from the liftgate.
Remove the liftgate handle gasket and discard.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.