Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009UPLANDER LT, 3.9 MREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSVEHICLE ACCESSREPAIR INSTRUCTIONSINTERIOR LAMP AND MULTIFUNCTION SWITCH REPLACEMENTREMOVAL PROCEDURE
2009 Chevrolet Uplander LT, 3.9 M
Removal Procedure
2009 Chevrolet Uplander LT, 3.9 MSECTION Removal Procedure
- Remove the courtesy lamp lens.
- Remove the overhead console screw.
- Grasp the overhead console and pull downward in order to disengage the fasteners.
- Disconnect the electrical connectors from the overhead console.
- Remove the power sliding door on/off multifunction switch (5) by using pliers in order to compress the retainers while pulling the switch away from the housing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.