Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009UPLANDER LT, 3.9 MREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - GROUND, ELECTRICAL CENTER IDENTIFICATION AND COMPONENT AND SPLICE PACK CONNECTOR END VIEWSCOMPONENT CONNECTOR END VIEWSDOOR JAMB SWITCH - LEFT REAR
2009 Chevrolet Uplander LT, 3.9 M
Door Jamb Switch - Left Rear
2009 Chevrolet Uplander LT, 3.9 MSECTION Door Jamb Switch - Left Rear
Door Jamb Switch - Left Rear
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| A | 0.35 L-BU/BK | 747 | Left Rear Door Ajar Switch Signal |
| B | 0.35 D-BU/WH | 1179 | Left Rear Door Open Switch Signal |
| C | 0.35 BK | 550 | Ground |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.