Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2009UPLANDER LT, 3.9 MREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEAT HARDWARE, TRIM, AND UPHOLSTERYREPAIR INSTRUCTIONSREAR STORAGE TRAY REPLACEMENT

2009 Chevrolet Uplander LT, 3.9 M

Rear Storage Tray Replacement

2009 Chevrolet Uplander LT, 3.9 MSECTION Rear Storage Tray Replacement

Fig 1: View Of Rear Storage Tray

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedures

Disable the SIR, if equipped. Refer to SIR Disabling and Enabling .
Remove the rear seat from the vehicle. Refer to Rear Seat Replacement (w/o SIAB) or Rear Seat Replacement (w/SIAB) .

Rear Seat Console Tray Bolt (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 32 N.m (24 lb ft)

Rear Seat Console Tray

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.