Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2009 Chevrolet Uplander LT, 3.9 MSECTION Removal Procedure
- Remove the rear seats. Refer to Rear Seat Replacement (w/o SIAB) or Rear Seat Replacement (w/SIAB) .
- Remove the rear left quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side .
- Remove the body pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement .
- Remove the front door sill plate. Refer to Door Sill Plate Replacement (Sliding Door) or Door Sill Plate Replacement (Door) .
- Remove the body side front trim panel retainers using the J 38778 .
- Remove the body side front trim panel from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.