Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISSTEERINGPOWER STEERING SYSTEMREPAIR INSTRUCTIONSSTUB SHAFT HOUSING REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C
Stub Shaft Housing Replacement
2009 Chevrolet Tahoe Base, 4.8 CSECTION Stub Shaft Housing Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedures: Remove the power steering gear. Refer to Steering Gear Replacement (Non-Rack and Pinion) or Steering Gear Replacement (Rack and Pinion) or Steering Gear Replacement (Two Mode Hybrid) . |
|
| 1 | Stub Shaft Housing Bolt (Qty: 4)
CAUTION:
Refer to Fastener Caution
.
Tighten: 62 N.m (46 lb ft) |
| 2 | Stub Shaft Housing |
| 3 | Stub Shaft Housing O-Ring (Qty: 2) Tip: Grease the stub shaft housing O-Rings with the special grease supplied in the service kit. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.