Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The drive motor generator battery control module is also referred to as the battery energy control module (BECM). The BECM will diagnose its own systems and determine when a fault condition is present. Diagnostics and system status is communicated from the BECM to the hybrid powertrain control module (HPCM) through serial data. The HPCM is the host controller for diagnostic trouble code (DTC) information.
The hybrid battery assembly consists of 40 individual batteries. Each battery is rated at 7.2 V. A pair of batteries is rated at 14.4 V. The batteries are connected together in a series circuit. The BECM monitors the hybrid battery voltage on every two batteries for a total of 20 locations, across the battery assembly. The BECM monitors and compares these 20 voltage measurements, if the BECM detects a voltage difference greater than a calibrated value on any two consecutive hybrid battery voltage measurements this DTC will set.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.