SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (HYBRID ENGINE CONTROLS - INTRODUCTION)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2009 Chevrolet Tahoe Base, 4.8 C

Fastener Tightening Specifications

2009 Chevrolet Tahoe Base, 4.8 CSECTION Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
Application Specification
Metric1 English
Accessory DC Power Control Module (APM) Bolts 10 N.m 89 lb in
Accessory DC Power Control Module (APM) Ground Strap Bolt 22 N.m 16 lb ft
Accessory DC Power Control Module (APM) Ground Strap Nut 9 N.m 80 lb in
Ball Stud 10 N.m 89 lb in
Drive Motor Generator Control Module Assembly Mounting Nuts 9 N.m 80 lb in
Drive Motor Generator Power Inverter Coolant Pipe Bolts 5 N.m 44 lb in
Drive Motor Generator Power Inverter Module (PIM) 3 Phase Cable Mounting Fasteners 9 N.m 80 lb in
Drive Motor Generator Power Inverter Module (PIM) 3 Phase Cable Terminal Fasteners 9 N.m 80 lb in
Drive Motor Generator Power Inverter Module (PIM) Cover Bolt 5 N.m 44 lb in
Drive Motor Generator Power Inverter Module (PIM) Distribution Box Cover Fasteners 9 N.m 80 lb in
High Voltage (HV) dc Accessory DC Power Control Module (APM) Terminal Fasteners 9 N.m 80 lb in
High Voltage (HV) dc Battery Cable Mounting Fasteners 9 N.m 80 lb in
High Voltage (HV) dc Battery Cable Terminal Fasteners 9 N.m 80 lb in
High Voltage (HV) dc Electric Air Conditioning Compressor (ACCM) Cable Mounting Fasteners 9 N.m 80 lb in
High Voltage (HV) dc Electric Air Conditioning Compressor (ACCM) Cable Terminal Fasteners 9 N.m 80 lb in
Sight Shield Circuit Breaker Bolts 5 N.m 44 lb in
Sight Shield Mounting Fastener 5 N.m 44 lb in
Shield Circuit Harness Terminal Fastener 9 N.m 80 lb in
Shield Circuit Harness Terminal Stud 6 N.m 53 lb in
1 N.m to kgf cm torque wrench formula = N.m value multiplied by 0.102
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.