Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The drive motor generator battery has four hybrid battery temperature sensors, an air inlet temperature sensor and an air outlet temperature sensor. The air inlet temperature sensor is referred to as sensor 1 and the air outlet temperature sensor is referred to as sensor 2. The hybrid battery temperature sensors are located on the top of the hybrid batteries. Both the hybrid battery temperature sensors and the air inlet and outlet sensors are a variable resistor that measures the temperature. The control module supplies 5 V to the signal circuit and a ground for the low reference circuit. The temperature sensor resistance changes with temperature. The lower the temperature, the higher the sensor resistance. The higher the temperature, the lower the sensor resistance. The drive motor generator battery control module (GBCM) uses these temperature sensors to determine the hybrid battery temperature and to control the battery vent fan operation.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.