Circuit/System Verification

2009 Chevrolet Tahoe Base, 4.8 CSECTION Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Ignition ON, engine running, increase engine speed to between 1,200-1,500 RPM. Monitor the camshaft actuator solenoid with a scan tool while observing the following control circuit status parameters:
    • The CMP actuator solenoid ckt short to gnd test status
    • The CMP actuator solenoid ckt open test status
    • The CMP actuator solenoid ckt short to volts test status
    • Each parameter should display OK.
  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.