Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 12 (HYBRID ENGINE CONTROLS - DTC P181C TO DTC P2797)DTC P1AFB OR P1B01CIRCUIT/SYSTEM TESTING
2009 Chevrolet Tahoe Base, 4.8 C
Circuit/System Testing
2009 Chevrolet Tahoe Base, 4.8 CSECTION Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF.
- Wait 2 minutes.
- Disconnect PIM connector X1.
- Ignition OFF.
- Wait 2 minutes.
- Reconnect PIM connector X1.
- Ignition ON, retest for DTC P1AFB or P1B01.
- If the DTC resets, program the PIM with the latest software version and recheck for DTCs. If the DTC resets after programming or if the PIM already contains the latest software version, replace the PIM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.