Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The torque converter clutch (TCC) signal circuit is a direct hardwire input to the engine control module (ECM) and transmission control module (TCM) from the body control module (BCM). The ECM monitors the stop lamp switch circuit to detect when the brake pedal has been applied. The BCM monitors the stop lamp switch to determine when the brake pedal is applied. When the brake pedal is applied, The BCM sends a GMLAN serial data message to the ECM indicating that the brake pedal has been applied. The BCM also sends a voltage signal on the stop lamp switch circuit to the ECM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.