SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 629 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC COMPASS MODULE TO MEMORY SEAT MODULE (X4))COMPONENT CONNECTOR END VIEWSHEATED SEAT ELEMENT- RIGHT REAR CUSHION (KA6)
2009 Chevrolet Tahoe Base, 4.8 C

Heated Seat Element- Right Rear Cushion (KA6)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Heated Seat Element- Right Rear Cushion (KA6)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM283890Courtesy of
Connector Part Information
  • Harness Type: Right Rear Seat
  • OEM Connector: 12066498
  • Service Connector: 12085536
  • Description: 4-Way F Metri-Pack 150 Series (BK)
Terminal Part Information
  • Terminated Lead: Pins A, B - 13505668
  • Terminated Lead: Pins C, D - 13575462
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-3 (GY)
  • Terminal/Tray: 12047581/2
  • Core/Insulation Crimp: Pins A, B - E/A
  • Core/Insulation Crimp: Pins C, D - E/C
Heated Seat Element- Right Rear Cushion (KA6)

Pin Wire Circuit Function
A 1 D-BU 2455 Heated Seat Element Control
B 1 BN 2297 Ground
C 0.35 OG 2300 Right Rear Heated Seat Sensor Signal
D 0.35 WH/BK 2301 Low Reference
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.