Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 566 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP FLOW CONTROL VALVE REPLACEMENT - OFF VEHICLE
2009 Chevrolet Tahoe Base, 4.8 C
Power Steering Pump Flow Control Valve Replacement - Off Vehicle
2009 Chevrolet Tahoe Base, 4.8 CSECTION Power Steering Pump Flow Control Valve Replacement - Off Vehicle
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Power Steering Pump Flow Control Valve Replacement - Off Vehicle
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the power steering pump assembly. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) . |
|
| 1 | Power Steering Fluid Reservoir |
| 2 | Power Steering Pump Fitting
CAUTION:
Refer to Fastener Caution . Tighten 75 N.m (55 lb ft) |
| 3 | Power Steering Pump Fitting Seal Procedure Apply power steering fluid to the power steering pump fitting seal before installing. |
| 4 | Power Steering Pump Flow Control Valve |
| 5 | Power Steering Pump Flow Control Valve Spring |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.