Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 554 (POWER SEAT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B1335CIRCUIT/SYSTEM TESTING
2009 Chevrolet Tahoe Base, 4.8 C
Circuit/System Testing
2009 Chevrolet Tahoe Base, 4.8 CSECTION Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
DTC B1335 00 or B1335 0B
- Ignition ON, use a scan tool to clear the current and history diagnostic trouble code.
- Determine which motor set this DTC by operating the motors listed below one at a time in both directions. Check for the DTC to set between each motor test.
- Driver seat front vertical motor
- Driver seat rear vertical motor
- Driver seat horizontal motor
- Driver seat recline motor
- Driver seat lumbar horizontal motor
- Driver seat lumbar vertical motor
- Adjustable pedal motor
- Clear the diagnostic trouble codes.
- Ignition OFF, disconnect the X1 harness connector at the appropriate seat adjuster assembly, lumbar adjuster assembly, or the adjustable pedal motor for which the DTC set.
- Ignition ON, operate the motor adjuster switch in both directions. DTC B1335 00 or B1335 0B should not set.
- If the DTC sets, test for a short between appropriate motor control circuits listed below. If the circuits test normal, replace the MSM.
- Front vertical motor terminal 2 and terminal 5
- Rear vertical motor terminal 1 and terminal 4
- Seat horizontal motor terminal 3 and terminal 6
- Seat recline motor terminal A and terminal B
- Lumbar vertical motor terminal A and terminal B
- Lumbar horizontal motor terminal C and terminal D
- Adjustable pedal motor terminal 4 and terminal 5
- Test the appropriate control circuits listed below for a high resistance. If all circuits test normal, test or replace the appropriate seat, lumbar, or adjustable pedal motor.
- Front vertical motor terminal 2 and terminal 5
- Rear vertical motor terminal 1 and terminal 4
- Seat horizontal motor terminal 3 and terminal 6
- Seat recline motor terminal A and terminal B
- Lumbar vertical motor terminal A and terminal B
- Lumbar horizontal motor terminal C and terminal D
- Adjustable pedal motor terminal 4 and terminal 5
DTC B1335 42 or B1335 4B
Verify that DTC B1335 42 or B1335 4B is not set.
- If either DTCs is set, replace the MSM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.