Installation Procedure

2009 Chevrolet Tahoe Base, 4.8 CSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Pressure Sensor (2500)
    GM1705812Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the seal on the fuel pressure sensor.
  2. Press the fuel pressure sensor into the line.
  3. Install the intermediate fuel and EVAP lines. Refer to Fuel Hose/Pipe Assembly Replacement (1500 SWB - 98.4L (26 gal) Tank + E85)Β , Fuel Hose/Pipe Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank)Β , Fuel Hose/Pipe Assembly Replacement (1500 LWB - 117.3L (31 gal) Tank + E85)Β , Fuel Hose/Pipe Assembly Replacement (1500 SWB - 98.4L (26 gal) Tank)Β .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.