SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 541 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MEMORY SEAT MODULE (X5) TO YAW SENSOR)COMPONENT CONNECTOR END VIEWSTURN SIGNAL/MULTIFUNCTION SWITCH X4 (C25)
2009 Chevrolet Tahoe Base, 4.8 C

Turn Signal/Multifunction Switch X4 (C25)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Turn Signal/Multifunction Switch X4 (C25)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM1639196Courtesy of
Connector Part Information
  • Harness Type: Steering Column
  • OEM Connector: 15418023
  • Service Connector: Service by Harness - See Part Catalog
  • Description: 5-Way M Unsealed (BK)
Terminal Part Information
  • Terminated Lead: Service by Harness - See Part Catalog
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-13
  • Terminal/Tray: SHCMW-A03T-040/20
  • Core/Insulation Crimp: J/J
Turn Signal/Multifunction Switch X4 (C25)

Pin Wire Circuit Function
1 WH 2283 Rear Wiper/Washer Switch Signal
2 GY 391 Rear Window Wiper Switch Signal
3 L-GN 2270 Rear Window Washer Relay Control
4-5 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.