SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 531 (MIRROR SYSTEM)REPAIR INSTRUCTIONSOUTSIDE REARVIEW MIRROR GLASS REPLACEMENTREMOVAL PROCEDURE
2009 Chevrolet Tahoe Base, 4.8 C

Removal Procedure

2009 Chevrolet Tahoe Base, 4.8 CSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING:

    Approved safety glasses and gloves should be worn when performing this procedure to reduce the chance of personal injury.

  1. Place masking tape over the mirror glass.
  2. Remove the outside rearview mirror courtesy lamp from the mirror housing, if equipped.
    3. Fig 1: Identifying Bottom Outboard Corner & Top Inboard Edge Corner
    GM1856429Courtesy of GENERAL MOTORS COMPANY
  3. Apply several layers of masking tape (1) to the mirror lower housing edge (2) to protect the finish.
    4. Fig 2: View Of Outside Rearview Mirror Glass & Special Tool
    GM2167086Courtesy of GENERAL MOTORS COMPANY
  4. Remove the mirror glass as follows:
    1. Place the mirror face flat to the housing.
    2. Insert a suitable rigid plastic tool (3) 3.81 cm (1.5 in) wide. Insert the rigid plastic tool (3) 3 cm (1.5 in) between the mirror lower housing edge (4) and the lower edge of the mirror glass (5).
    3. Holding the tool in place, press forward on the lower edge of the glass, this will release the tabs from the motor/actuator ring.
  5. Disconnect the electrical connectors from the back of the mirror glass.
    6. Fig 3: Identifying Outside Rearview Mirror Motor/Actuator
    GM2167079Courtesy of GENERAL MOTORS COMPANY
  6. The motor/actuator ring (1) must stay with the motor/actuator, not with the mirror glass (2).
    7. Fig 4: View Of Outside Rearview Mirror Motor/Actuator
    GM2167074Courtesy of GENERAL MOTORS COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.