SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 525 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSROOF CONSOLE REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Roof Console Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Roof Console Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Roof Console Assembly & Components
GM1709828Courtesy of GENERAL MOTORS COMPANY
Roof Console Replacement

Callout Component Name
1 Roof Console Dome and Reading Lamp Lens
2 Roof Console Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
3 Roof Console Assembly
CAUTION:

Do not exert downward force at the forward or rearward edge of the roof console assembly as irreversible damage will occur.

Procedures

  1. Grasp the right and left sides of the roof console assembly where indicated with arrows and pull downward using equal force on each side in order to release the retainer clips securing the overhead console assembly to the headlining assembly.
  2. Disconnect the electrical connectors.
  3. If replacing roof console assembly, transfer all necessary components.
4 Roof Console Retainers (Qty: 2)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.