Headlamp Control Module Replacement (Escalade PLATINUM)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Headlamp Control Module Replacement (Escalade PLATINUM)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Headlamp Control Module Replacement
GM2039271Courtesy of GENERAL MOTORS COMPANY
Headlamp Control Module Replacement (Escalade PLATINUM)

Callout Component Name
Preliminary Procedure 
Remove the headlamp assembly. Refer to Headlamp Replacement (Escalade PLATINUM) .
1 ELC Module Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
Hand tighten the screws evenly after installation of the ELC module to the headlamp connector.
2 ELC Module
TIP:  Pull the module straight from the headlamp connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.