SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 494 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULE)COMPONENT CONNECTOR END VIEWSLIFTGATE LATCH ASSEMBLY (E52 WITH E61)
2009 Chevrolet Tahoe Base, 4.8 C

Liftgate Latch Assembly (E52 with E61)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Liftgate Latch Assembly (E52 with E61)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Liftgate Latch Assembly (E52 with E61) Connector End View
GM1711025Courtesy of GENERAL MOTORS CORP.
Liftgate Latch Assembly (E52 with E61)

Pin Wire Circuit Function
1 2 BN 5790 Liftgate Cinch Latch Motor Open Control
2 0.35 PU/WH 5801 Low Reference
3 2 L-BU 5791 Liftgate Cinch Latch Motor Close Control
4 0.35 D-GN 5512 Latch Sector Switch Signal
5 0.35 GY 7000 Latch Pawl Switch Signal
6 0.35 PK/BK 6000 Latch Ratchet Switch Signal
Connector Part Information
  • Harness Type: Liftgate
  • OEM Connector: 15476196
  • Service Connector: 88988498
  • Description: 6-Way F GT 280 Series Sealed (BK)
Terminal Part Information
  • Pins: 1, 3
  • Terminated Lead: 13575392
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 15304720/19
  • Core/Insulation Crimp: 4/5
  • Pins: 2, 4-6
  • Terminated Lead: 13575406
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 15304719/19
  • Core/Insulation Crimp: E/5
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.