SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 494 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULE)COMPONENT CONNECTOR END VIEWSHEATED AND COOLED CUP HOLDER (ULT)
2009 Chevrolet Tahoe Base, 4.8 C

Heated and Cooled Cup Holder (ULT)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Heated and Cooled Cup Holder (ULT)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated and Cooled Cup Holder (ULT) Connector End View
GM1849816Courtesy of GENERAL MOTORS CORP.
Heated and Cooled Cup Holder (ULT)

Pin Wire Circuit Function
A 0.5 BK 1050 Ground
B 0.35 YE 6817 LED Backlight Dimming Control
C 0.35 PU/WH 6816 LED Backlight Dimming Control
D 0.35 OG 300 Ignition Voltage
E 0.5 RD/WH 2640 Battery Positive Voltage
Connector Part Information
  • Harness Type: Floor Console
  • OEM Connector: 15332138
  • Service Connector: 19153137
  • Description: 5-Way F GT 150 Series (BK)
Terminal Part Information
  • Terminated Lead: 13575735
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-2A (GY)
  • Terminal/Tray: 12191812/19
  • Core/Insulation Crimp: E/C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.