SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 494 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULE)COMPONENT CONNECTOR END VIEWSHEATED SEAT CONTROL MODULE - REAR X1 (KA6)
2009 Chevrolet Tahoe Base, 4.8 C

Heated Seat Control Module - Rear X1 (KA6)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Heated Seat Control Module - Rear X1 (KA6)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Control Module - Rear X1 (KA6) Connector End View
GM1664577Courtesy of GENERAL MOTORS CORP.
Heated Seat Control Module - Rear X1 (KA6)

Pin Wire Circuit Function
1 - - Not Used
2 1 BN 2297 Ground
3 1 PK 2445 Heated Seat Element Control
4 - - Not Used
5 1 BN 2295 Ground
6 1 D-BU 2455 Heated Seat Element Control
Connector Part Information
  • Harness Type: Left Rear Seat
  • OEM Connector: 6098-4606
  • Service Connector: Service by Harness - See Part Catalog
  • Description: 6-Way F (BN)
Terminal Part Information
  • Terminal/Tray: 8100-4444/22
  • Core/Insulation Crimp: 2/A
  • Release Tool/Test Probe: 15315247/J-35616-35 (VT)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.