SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 488 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSELECTRONIC BRAKE CONTROL MODULE (EBCM) (HP2)
2009 Chevrolet Tahoe Base, 4.8 C

Electronic Brake Control Module (EBCM) (HP2)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Electronic Brake Control Module (EBCM) (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electronic Brake Control Module (EBCM) (HP2) Connector End View
GM1862109Courtesy of GENERAL MOTORS CORP.
Electronic Brake Control Module (EBCM) (HP2)

Pin Wire Circuit Function
1 5 RD/BK 1742 Battery Positive Voltage
2 0.5 BN 882 Wheel Speed Sensor (WSS) - Right Rear Signal
3 0.5 GY/BK 7128 12-Volt Reference
4 0.5 GY/BK 7127 12-Volt Reference
5 0.5 TN 884 Wheel Speed Sensor (WSS) - Left Rear Signal
6 0.5 D-GN 872 Wheel Speed Sensor (WSS) - Right Front Signal
7 0.5 YE 6046 Steering Angle Sensor - Phase A
8 0.5 TN 6048 Steering Angle Sensor - Index
9 0.5 RD/BK 442 Brake Master Cylinder Piston Position Sensor Signal
10 - - Not Used
11 0.5 L-BU/WH 6311 Brake Applied Signal
12 0.5 L-BU 5986 Serial Data Communication Enable
13 5 BK 2150 Ground
14 0.5 PK 439 Ignition Voltage
15 0.5 OG/BK 6045 Low Reference
16 0.5 L-GN 6043 Steering Angle Sensor Signal
17 0.5 GY/WH 7065 12-Volt Reference
18 0.5 TN 948 Ignition Voltage
19 0.5 GY 6044 5-Volt Reference
20 0.5 D-BU 6047 Steering Angle Sensor - Phase B
21 0.5 L-BU 6106 PTLAN -
22 0.5 L-BU/WH 6106 PTLAN -
23 0.5 TN 2501 High Speed GMLAN Serial Data Bus -
24 0.5 TN 2501 High Speed GMLAN Serial Data Bus -
25 3 RD/BK 442 Battery Positive Voltage
26-27 - - Not Used
28 0.5 GY/WH 7064 12-Volt Reference
29 0.5 L-BU/BK 830 Wheel Speed Sensor (WSS) - Left Front Signal
30 0.5 TN/WH 950 Yaw Rate and Lateral Acceleration Sensor Ground
31 0.5 RD 442 5-Volt Reference
32 0.5 D-GN/WH 817 Vehicle Speed Signal
33 0.5 D-BU 6105 PTLAN +
34 0.5 D-BU/WH 6105 PTLAN +
35 0.5 RD/BK 442 Brake Master Cylinder Piston Position Sensor Signal
36 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus +
37 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus +
38 3 BK 2150 Ground
Connector Part Information
  • Harness Type: Chassis
  • OEM Connector: 13528146
  • Service Connector: 19178085
  • Description: 38-Way F 2.8 Series, Sealed (BK)
Terminal Part Information
  • Pins: 1, 13
  • Terminated Lead: 13575383
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-42 (RD)
  • Terminal/Tray: 7116-4142-02/10
  • Core/Insulation Crimp: D/3
  • Pins: 2-9, 11, 12, 14-24, 28-37
  • Terminated Lead: 13578883
  • Release Tool: Pending
  • Diagnostic Test Probe: Pending
  • Terminal/Tray: Pending
  • Core/Insulation Crimp: Pending
  • Pins: 25, 38
  • Terminated Lead: 13575403
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 15304720/19
  • Core/Insulation Crimp: 4/5
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.