SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 488 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSDOOR LATCH - DRIVER
2009 Chevrolet Tahoe Base, 4.8 C

Door Latch - Driver

2009 Chevrolet Tahoe Base, 4.8 CSECTION Door Latch - Driver
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Latch - Driver Connector End View
GM845631Courtesy of GENERAL MOTORS CORP.
Door Latch - Driver

Pin Wire Circuit Function
1 - - Not Used
2 0.5 PU 5927 Driver Door Lock Motor Unlock Control
3 0.5 TN 5925 Driver Door Lock Motor Common
4-5 - - Not Used
6 0.35 GY/BK 745 Left Front Door Ajar Switch Signal
7 - - Not Used
8 0.35 YE 5942 Low Reference
9-10 - - Not Used
Connector Part Information
  • Harness Type: Driver Door
  • OEM Connector: 10768367
  • Service Connector: 88952463
  • Description: 10-Way F Series, Sealed (BK)
Terminal Part Information
  • Terminated Lead: 13575550
  • Release Tool: J-38125-559
  • Diagnostic Test Probe: J-35616-16 (L-GN)
  • Terminal/Tray: 15445905/23
  • Core/Insulation Crimp: J/J
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.