SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 488 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSDIGITAL VIDEO DISC (DVD) DISPLAY - REAR (DNU)
2009 Chevrolet Tahoe Base, 4.8 C

Digital Video Disc (DVD) Display - Rear (DNU)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Digital Video Disc (DVD) Display - Rear (DNU)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Digital Video Disc (DVD) Display - Rear (DNU) Connector End View
GM1711011Courtesy of GENERAL MOTORS CORP.
Digital Video Disc (DVD) Display - Rear (DNU)

Pin Wire Circuit Function
1 0.35 L-GN 7396 DVD Video Signal 2 (+)
2 0.35 WH 7394 DVD Video Signal 2 (-)
3-4 - - Not Used
5 0.5 BK 2550 Ground (Z75)
0.35 BK 2550 Ground (X88 or Z88)
6 0.5 BK 2550 Ground
7 0.5 RD/WH 1540 Battery Positive Voltage (Z75)
0.5 RD/WH 3240 Battery Positive Voltage (X88 or Z88)
8 0.35 WH 7066 Entertainment Remote Enable Signal
9 0.35 PK/BK 5844 Video Bright Control
10 0.35 D-GN/WH 7395 Video Mode 2 Signal
Connector Part Information
  • Harness Type: Headliner
  • OEM Connector: 15490628
  • Service Connector: 89047355
  • Description: 10-Way F Kaizen 0.64 Series (BK)
Terminal Part Information
  • Terminated Lead: 13575845
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.