SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 488 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1)COMPONENT CONNECTOR END VIEWSACCESSORY POWER OUTLET - 110V AC (HP2)
2009 Chevrolet Tahoe Base, 4.8 C

Accessory Power Outlet - 110V AC (HP2)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Accessory Power Outlet - 110V AC (HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Accessory Power Outlet - 110V AC (HP2) Connector End View
GM1540771Courtesy of GENERAL MOTORS CORP.
Accessory Power Outlet - 110V AC (HP2)

Pin Wire Circuit Function
1 0.8 WH 6807 Plug Switch Signal
2 - - Not Used
3 0.8 BK 5683 110 VAC +
4 0.5 BN 241 Ignition Voltage
5 - - Not Used
6 0.8 D-BU 5685 110 VAC -
Connector Part Information
  • Harness Type: AC Outlet Extension
  • OEM Connector: 6098-4536
  • Service Connector: Service by Harness - See Part Catalog
  • Description: 6-Way F 2.8 Series (OG)
Terminal Part Information
  • Terminal/Tray: Service by Harness - See Part Catalog
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.