Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 428 (HYBRID/EV CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P06AFCIRCUIT/SYSTEM TESTING
2009 Chevrolet Tahoe Base, 4.8 C
Circuit/System Testing
2009 Chevrolet Tahoe Base, 4.8 CSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, remove the F103 drive motor generator control module sight shield. Refer to Drive Motor Generator Control Module Sight Shield ReplacementΒ .
- Disconnect the T6 drive motor generator power inverter module X1 connector and the ECM X3 connector.
- Test for less than 1 Ξ© between the serial data circuits listed below:
- T6 drive motor generator power inverter module X1 connector terminal 10 and K20 ECM X3 connector terminal 33
- T6 drive motor generator power inverter module X1 connector terminal 11 and K20 ECM X3 connector terminal 53
- If greater than the specified range, test the serial data circuit for an open/high resistance condition. If the circuit tests normal, replace the K20 ECM.
- If the DTC is set, program the T6 drive motor generator power inverter module. If the DTC resets, replace the T6 drive motor generator power inverter module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.