SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 376 (WIPER SYSTEM AND WASHER SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESREAR WIPER SYSTEM MALFUNCTIONCOMPONENT TESTING
2009 Chevrolet Tahoe Base, 4.8 C

Component Testing

2009 Chevrolet Tahoe Base, 4.8 CSECTION Component Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Rear Window Wiper Switch

  1. Ignition OFF, disconnect the X4 harness connector at the turn signal multifunction switch.
  2. Rear wiper switch OFF, test for infinite resistance between the ignition terminal 1 and the signal terminal 2.
    • If not the specified value, replace the turn signal multifunction switch.
  3. Rear wiper switch in the ON position, test for 2000-2400 ohms between the ignition terminal 1 and the signal terminal 2.
    • If not within the specified range, replace the turn signal multifunction switch.
  4. With the rear wiper switch in the DELAY position, test for 900-1.5K ohms between the ignition terminal 1 and the signal terminal 2.
    • If not within the specified range, replace the turn signal multifunction switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.