Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 301 (HYBRID ENGINE COOLING SYSTEM)COMPONENT LOCATORGENERATOR BATTERY TEMPERATURE SENSOR LOCATION
2009 Chevrolet Tahoe Base, 4.8 C
Generator Battery Temperature Sensor Location
2009 Chevrolet Tahoe Base, 4.8 CSECTION Generator Battery Temperature Sensor Location
WARNING: This page is about a different car, the 2010 GMC Yukon, 2010 Chevrolet Tahoe, and 2010 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Hybrid Battery Temperature Sensor Location
| Sensor1 | Location2 |
|---|---|
| Hybrid Batt Mod 1 Temperature | Hybrid Battery Module 1 |
| Hybrid Batt Mod 2 Temperature | Hybrid Battery Module 14 |
| Hybrid Batt Mod 3 Temperature | Hybrid Battery Module 27 |
| Hybrid Batt Mod 4 Temperature | Hybrid Battery Module 40 |
| Hybrid Batt Outlet Air Temperature | Air Inlet Duct near hybrid battery fan |
| Hybrid Batt Inlet Air Temperature | Clipped above Hybrid Battery Module 3 |
| 1
Scan tool parameter name 2 Battery 1 is located next to cooling fan assembly. Battery 40 is located next to drive motor generator battery control module. |
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.