SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSCENTER CONSOLE END PANEL REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Center Console End Panel Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Center Console End Panel Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Floor Console End Cap Assembly & Screws
GM1693888Courtesy of GENERAL MOTORS CORP.
Center Console End Panel Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the front floor console compartment bezel. Refer to Front Floor Console Compartment Bezel Replacement (Cadillac)  or Front Floor Console Compartment Bezel Replacement (Except Cadillac) .
  2. Remove the front floor console rear cupholder. Refer to Cup Holder Replacement - Front Floor Console - Rear (Cadillac) or Cup Holder Replacement - Front Floor Console - Rear (Except Cadillac) .
1 Front Floor Console End Cap Screws (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)
2 Front Floor Console End Cap Assembly
Tip:  Disconnect the electrical connections.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.