SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 28 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR BATTERY JUMPER CABLE REPLACEMENTINSTALLATION PROCEDURE
2009 Chevrolet Tahoe Base, 4.8 C

Installation Procedure

2009 Chevrolet Tahoe Base, 4.8 CSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Battery Jumper Cable
    GM1702992Courtesy of GENERAL MOTORS CORP.
  1. Install the generator battery jumper cable to the vehicle.
    2. Fig 2: View Of Generator Battery Jumper Cable & Components
    GM1699546Courtesy of GENERAL MOTORS CORP.
  2. Install the generator battery jumper cable terminal (4) to the mega fuse stud.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the generator battery jumper cable to mega fuse nut (3).

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  4. Install the generator battery jumper cable clip (2) to A/C evaporator tube.
  5. Install the generator battery jumper cable clip (1) to the stud.
    6. Fig 3: View Of Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS CORP.
  6. Install the mega fuse cover.
    7. Fig 4: View Of Battery Jumper Cable Terminal, Nut & Bolt
    GM1702914Courtesy of GENERAL MOTORS CORP.
  7. Install the generator battery jumper cable terminal (1) to the generator stud.
  8. Install the generator battery jumper cable nut (2) to the generator.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  9. Position the generator battery jumper cable boot (3).
  10. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.