SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 261 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSSTEERING GEAR BOOT REPLACEMENT (WITHOUT HP2)INSTALLATION PROCEDURE
2009 Chevrolet Tahoe Base, 4.8 C

Installation Procedure

2009 Chevrolet Tahoe Base, 4.8 CSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rack And Pinion Boot & Boot Clamp
    GM1759493Courtesy of GENERAL MOTORS CORP.
  1. Position the NEW inner boot clamp (1) onto the steering gear boot (2).
    2. Fig 2: View Of Rack And Pinion Gear Assembly, Inner Tie Rod Assembly & Rack And Pinion Boot
    GM1759513Courtesy of GENERAL MOTORS CORP.
  2. Apply grease to the steering linkage inner tie rod (2) and to the steering gear (1).
  3. Install the steering gear boot (3) onto the steering linkage inner tie rod.
  4. Ensure the steering gear boot is not twisted, puckered, or improperly folded.
  5. Install the steering gear boot onto the steering gear. Seat the steering gear boot in the groove on the steering gear housing.
    6. Fig 3: View Of Rack & Pinion Boot & Boot Clamp
    GM1759515Courtesy of GENERAL MOTORS CORP.
  6. Install the inner boot clamp (1) to the steering gear boot (2) with the J-22610:  pliers.
    7. Fig 4: View Of Rack & Pinion Boot & Clamp
    GM1759500Courtesy of GENERAL MOTORS CORP.
  7. Install the outer boot clamp (2) to the steering gear boot (1).
    8. Fig 5: View Of Inner Tie Rod Assembly & Hex Jam Nut
    GM1759516Courtesy of GENERAL MOTORS CORP.
  8. Install the steering linkage inner tie rod nut (2) to the steering linkage inner tie rod (1).
  9. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.