Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 254 (HYBRID ENGINE ELECTRICAL SYSTEM)REPAIR INSTRUCTIONSBATTERY CURRENT SENSOR REPLACEMENTINSTALLATION PROCEDURE
2009 Chevrolet Tahoe Base, 4.8 C
Installation Procedure
2009 Chevrolet Tahoe Base, 4.8 CSECTION Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Yukon, 2010 Chevrolet Tahoe, and 2010 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Squeeze the negative battery cable branches together.
- Slide the NEW battery current sensor (2) up onto the negative battery cable to the location previously marked during removal.
- Wrap electrical tape around the battery current sensor leg in order to secure the sensor to the negative battery cable.
- Install the negative battery cable clip (1) to the cable to the location previously marked during removal.
- Install the negative battery cable. Refer to Battery Negative Cable Replacement .
NOTE:
Ensure the battery current sensor is installed in the correct direction and location on the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.