Remote Control Door Lock Receiver Antenna Replacement (Except Avalance/Escalade EXT)

2009 Chevrolet Tahoe Base, 4.8 CSECTION Remote Control Door Lock Receiver Antenna Replacement (Except Avalance/Escalade EXT)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remote Control Door Lock Receiver Antenna
GM2164143Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the back rear corner upper garnish molding. Refer to Body Rear Corner Garnish Molding Replacement - Left Side (w/E61) or Body Rear Corner Garnish Molding Replacement - Left Side (w/o E61) .
1 Remote Control Door Lock Receiver Antenna

Procedure

  1. Disconnect the antenna from the remote control door lock receiver.
  2. Note the routing of the antenna.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.