Garage Door Opener Transmitter Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Garage Door Opener Transmitter Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Garage Door Opener Transmitter Assembly & Screws
GM1709050Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Lower the overhead console enough to access the garage door opener. Refer to Roof Console Replacement .
1 Garage Door Opener Transmitter Screws (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:Β  2 N.m (18 lb in)

2 Garage Door Opener Transmitter Assembly

Procedure

  1. Disconnect the electrical connection.
  2. Refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.