SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 233 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD SIDE REVEAL MOLDING REPLACEMENT
2009 Chevrolet Tahoe Base, 4.8 C

Windshield Side Reveal Molding Replacement

2009 Chevrolet Tahoe Base, 4.8 CSECTION Windshield Side Reveal Molding Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Window Side Reveal Molding, Screws & Nuts
GM1669885Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Open the front door on the side the reveal molding is being serviced.
  2. Pull the door auxiliary weatherstrip up to the roof header.
  3. Remove the air inlet grille panel end cap.
1 Reveal Molding Nut
2 Windshield Side Reveal Molding
Tip:  Upon installation, tuck the bottom edge of the reveal molding under the end cap of the air inlet grille panel prior to the screw installation.
3 Windshield Side Reveal Molding Screw (Qty: 5)
CAUTION: Refer to Fastener Caution .

Tighten:  2 N.m (18 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.