SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TAHOE BASE, 4.8 CREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 233 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTREMOVAL PROCEDURE
2009 Chevrolet Tahoe Base, 4.8 C

Removal Procedure

2009 Chevrolet Tahoe Base, 4.8 CSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  1. Remove the fixed antenna mast if equipped. Refer to Radio Antenna Replacement .
  2. Open the hood.
  3. Remove the window wiper arms. Refer to Windshield Wiper Arm Replacement (Chevrolet Hybrid Two-mode) or Windshield Wiper Arm Replacement (Conventional) .
  4. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
    5. NOTE: If the outside moisture sensor was remove from the windshield the lens must be replaced.
  5. Remove the outside moisture sensor lens. Refer to Windshield Outside Moisture Sensor Lens Replacement .
  6. Remove the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
    7. Fig 1: View Of Front Door Sealing Weatherstrips & Side Reveal Molding Screws
    GM1743196Courtesy of GENERAL MOTORS CORP.
  7. Reposition the front door sealing weatherstrips (1) in order to access the side reveal molding screws. You do not have to remove the front door sealing weatherstrip completely from the vehicle.
    8. Fig 2: Removing/Installing Screws From Window Side Reveal Moldings
    GM1743200Courtesy of GENERAL MOTORS CORP.
  8. Remove the screws from the left and the right sides of window side reveal moldings.
  9. Remove the reveal side moldings from the vehicle.
    10. WARNING: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
  10. Cover the following parts to protect from broken glass:
    1. The upper dash pad
    2. The defroster outlets and A/C outlets
    3. The seats and the carpeting
    11. Fig 3: Window Lower Supports
    GM698561Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.